MLFH330 無限コーティングプレミアム 高能率レンズ形3枚刃エンドミル

7 ⾼硬度鋼 Hardened Steels H プリハードン鋼 Prehardened Steels P ■ MLFH330活用講座動画 ■ ツールパス作成時のポイント Points of creating tool paths MLFH330をより効果的にご活用いただけるよう、 この度活用講座動画を制作いたしました。是非ご覧ください ・ 傾斜角が底刃半径での加工範囲を超えず、最大傾斜角以内であることを確認してください ・ びびりが発生しやすくなるためコーナ半径部や外周刃での切削はしないようにしてください。斜面などでかけ上がり時 にコーナ半径部での切削になってしまう場合は、かけ下がりになるよう加工方向を変更してください · Please make sure that the inclination angle does not exceed the cutting range at the end cutting edge radius and within the maximum inclination angle · Avoid cutting with the corner radius or peripheral cutting edge as this is likely to cause vibration. If cutting is done with the corner radius when ascending on a slope, change the cutting direction so that cutting is done with the corner radius 活用講座動画 最大傾斜角︓21° Maximum inclined angle 底刃半径部での切削 Cutting at the bottom radius 〇 びびり無し No chattering 工具の送り方向 Tool feed direction かけ上がり コーナ半径部の接触がない場合 Running up When no contact at the corner radius 工具の送り方向 Tool feed direction 最大傾斜角を超える角度 When exceed the maximum inclined angle びびり有り Chattering コーナ半径部での切削 Cutting by corner radius ✖ かけ上がり 最大傾斜角を超えた場合 Running up When exceed the maximum inclined angle 最大傾斜角︓21° Maximum inclined angle コーナ半径部での切削 Cutting by corner radius ✖ びびり有り Chattering 工具の送り方向 Tool feed direction かけ上がり コーナ半径部の接触がある場合 Running up When contact at the corner radius 最大傾斜角︓21° Maximum inclined angle 底刃半径部での切削 Cutting at the bottom radius 〇 びびり無し No chattering 工具の送り方向 Tool feed direction かけ下がり コーナ半径部の接触がない場合 Running down When no contact at the corner radius

RkJQdWJsaXNoZXIy NDY3NTA=